int sensorState = 0;

void setup()
{
  pinMode(2, INPUT);
  pinMode(13, OUTPUT);
  Serial.begin(9600);

}

void loop()
{
  // read the state of the sensor/digital input
  sensorState = digitalRead(7);
  // check if sensor pin is HIGH. if it is, set the
  // LED on.
  if (sensorState == HIGH) {
    digitalWrite(13, HIGH);
    Serial.println("Ryx!");
  } else {
   Serial.println("Tixo!");
    digitalWrite(13, LOW);
      
  }
  delay(10); // Delay a little bit to improve simulation performance
}